Filter
Top Products
13
4
STEP
• Both swing arm covers (C13) must be
placed on the front of the main seat support
with tallest sides facing rear of machine.
Align bottom two holes on covers with the
front two holes along bottom edge of main
seat support (AC1). Attach using two bolts
(M10x123), four flat washers (10.2x22x2),
and two nylon nuts (M10).
• Take the swing arm without the pulleys
(AD2) and align the holes at either end
with the front swing arm bracket on
main seat support. Slide the 105mm shaft
(Z19) through holes in swing arm cover,
bracket, and spacer (one 20x30x1 on
each side of swing arm). Use two bolts
(M10x25), two lock washers (10.2x18.4x2.5),
and two flat washers (10x25x2) to secure.
Repeat using the swing arm with pulleys
(AD1), making sure the pulleys are down,
facing the pulleys on the main seat support.
Check diagram for clarification. Make
sure the flats of the shafts line up with those
of the mounting brackets.
• Attach foot plate (AD3) to the top of both
swing arms (AD1&AD2) using one 98mm
shaft (Z18), two bolts (M10x25), two flat
washers (10x25x2), two lock washers
(10.2x18.4x2.5), and two spacers
(20x30x1) for each swing arm connection.
Make sure the flats of the shafts line up
with those of the mounting brackets.
Tighten all hardware.
GREEN BAG
AC1
AC1
AD1
AD1
C13
C13
C13
C13
AD2
AD2
AD3
AD3
Z18
Z18
Z18
Z18
Z19
Z19
Z19
Z19