Filter
Top Products
12
3
STEP
• Loosely secure top and bottom shield
brackets (B10) to weight stack tower
(AB1) using eight bolts (M5x10), eight flat
washers (5.2x10x1.5), and eight lock
washers (5.1x9.3x1.3) provided. Repeat
for all side brackets (B09).
• Place two rubber weight plate bumpers
(Z42) over the holes in the weight stack
tower. With the horizontal holes at the
top, place the guide rods over and
through the rubber weight plate bumpers
and into the weight stack tower. Let the
guide rods tilt outward from the tower.
Slide each of the 20 weight plates over
both of the guide rods on top of one
another. Place the header weight plate
(K01) over both guide rods on top of other
weight plates.
• Slip the rubber guide rod sleeves (Z41)
over the top of the guide rods, then snap
into holes in the weight stack tower. Lift the
guide rods into top of weight stack tower
until holes in the guide rod are lined up
with the horizontal holes on the top of the
weight stack tower. Insert a bolt (M8x62)
and flat washer (8.4x15.5x1.6) through
each guide rod and fasten with another
flat washer and nylon nut (M8).
PINK BAG
AB1
AB1
Z41
Z41
Z42
Z42
Z42
Z42
B10
B10
B09
B09
B09
B09