Filter
Top Products
17
8
STEP
• Attach the stabilizer tube (AG4) to the
weight stack tower by inserting two bolts
(M10x140) and two flat washers
(10.2x22x2) through the bracket and the
tower tube. Fasten two flat washers
(10.2x22x2) and two nylon nuts (M10).
Attach two bolts (M10x70), four flat wash-
ers (10.2x22x2), and two nylon nuts
(M10) to the opposite end of the tube.
• Install the left (AE2) and right (AE1)
handlebars on the seat support (AC1)
using two bolts (M10x75), four flat washers
(10.2x22x2), and two nylon nuts (M10).
• Install seat bottom (J02) on seat support
using four bolts (M10x25).
• Mount the thigh pad (J03) onto the thigh
support (AD3) using two bolts (M10x70).
• Attach the seat back (J01) to the seat
back post (AJ1) using four bolts (M10x25).
Insert seat back post into seat back
support tube. Thread pull pin into seat
back support until the seat back post locks
into location.
• Slide leg pad (J04) onto leg pad shaft
(AD2) and secure using disc (D41), a flat
washer (8.4x15.5x1.6), a lock washer
(8.2x15.4x2), and a bolt (M8x25).
LIGHT BLUE BAG