Filter
Top Products
14
5
STEP
• Loosely secure top and bottom shield
brackets (B10) to weight stack tower using
bolts (M5x10), flat washers (5.3x10x1),
and lock washers (5.1x9.3x1.3) provided.
Repeat for all side brackets (B09).
• Place two rubber weight plate bumpers
(Z14) over the holes at the bottom of the
weight stack tower. With the horizontal
holes of the guide rods (K05) at the top,
place them over and through the rubber
weight plate bumpers into the weight stack
tower. Let the guide rods tilt outward from
the tower. Slide each of the 15 weight
plates (K02) over both of the guide rods on
top of one another. Place the header weight
plate (K01) over both guide rods on top of
other weight plates.
• Make sure rubber guide rod sleeves (Z15)
are in place in top holes of the weight stack
tower. Lift the guide rods into top of weight
stack tower until holes in the guide rod are
lined up with the horizontal holes on the top
of the weight stack tower. Insert a bolt
(M8x62), and a flat washer (8.4x15.5x1.6)
through each guide rod and fasten with a
flat washer (8.4x15.5x1.6) and a nut (M8).
BLACK BAG