Vision Fitness ST750 Home Gym User Manual


 
15
6
STEP
• With the loop end of the cable in your
hand, guide cable through hole in top of
weight stack tower and around pulleys A
and B. Bring it down along weight stack
tower and through pulleys C and D.
Cable will then go towards the dual pulley
bracket through pulleys E and F, then
secure the loop end of the cable at the
connection point on the swing arm plate
using two spacers (10.2x20x6), one bolt
(M8x37.5), a flat washer on each side
(10.2x22x2) and one nut (M8).
• Remove nut on bolt end of cable and
place the selector pin tether (K08) on bolt
shaft. Thread the nut back on the bolt end
of the cable all the way to the head of the
bolt. Thread the bolt into the header plate,
making sure that there is a minimum of
0.5” of engagement. Secure by tightening
nut onto header plate (K01).
YELLOW BAG
A
B
C
D
E
F
K08
K08
K01
K01