Filter
Top Products
4
O W N ER ’ S M AN U AL
PEDALS
The pedals are distinguished by the markings R (= right)
and L (= left) on their shafts. Fasten the right pedal to
the right pedal crank turning clockwise and the left
pedal to the left pedal crank turning counterclockwise.
Fasten the pedal bands first into the retainerat the
device. Thread the band through the pedal loop and
push the band opening into the projection in the pedal.
Fasten the pedal bands to the pedal outside. Push the
band through the locking buckle and the band locks
automatically. The length of the band can be adjusted
with the locking buckle.
HANDLEBAR
Attach the cable coming from the frame tube to the
connector at the bottom of the handlebar. Ensure that
the joint is securely locked by gently pulling the wire.
Thread the wire carefully inside the frame tube. Open
the handlebar locking knob by turning it anticlockwise
a few times and then pulling it outwards. Insert the
handlebar into the front frame tube. Release the locking
knob once the handlebar has reached the required level.
Ensure that the handlebar is locked. Secure and tighten
the locking knob by turning it clockwise.
CONSOLE
Connect the cables from the handlebar to the
corresponding connectors of the console. Insert the
connected cables into the console, but make sure they
are not damaged when the console is attached. Place the
meter in position at the end of the handlebar support
tube and attach the console using 4 mounting screws.
SEAT
Loosen the seatholder locking screw and turn the upper
locking lever so that it is aligned with the equipment.
Place the seat into position on the grooves of the lower
locking lever. Turn the upper locking lever towards the
top of the seat rails and lock the seat by tightening the
locking screw.