Filter
Top Products
TOPCOM HB 10M00
16
8.2 SENSOR MODE OVERVIEW
8.2.1 Heartbeat measurement
See “8 Timekeeping - Sensor mode main menu” how to enter the heart beat
measurement menu (HR).
PRECAUTIONS
• Avoid fastening the strap too tight.
• Do not bend or fold the chest belt for preventing damage.
• Wetting the skin, where there is contact with the conductive area of
the chest belt, will improve the conduction and get a more stable sig-
nal.
• The physical condition of an individual might effect the intensity of
measured signal.
• Avoid using the heart rate monitor close to a trolley car, a tram stop,
transformer, electric substation and high-tension distribution lines etc.
The radio signal will be affected under influence of the environment
from high voltage and strong electromagnetic fields.
8.2.2 Using the transmitter belt.
Fasten the fastener at one end. Try the chest belt on your chest and loosen
the stretch band if necessary.
Adjust the length of the stretch band until it feels conformable. The stretch
band must cling to the chest. Fasten the fastener at the other end. Adjust
the sensor to the center of your chest and be sure the backside of the
sensor clings to your chest and touches the skin.
The chest strap must be paired with the watch. See “7.1 To pair
the watch with the chest belt and GPS pod” for detailed pairing
operation!