Filter
Top Products
TIMEX
®
IRONMAN
®
Classic 50 Move+ Owner’s Manual Page 5
WATER & SHOCK RESISTANCE
Your watch is 100 meter (328 ft) water resistant, 160 pounds per square inch absolute.
WARNING: TO MAINTAIN WATER-RESISTANCE, DO NOT PRESS ANY BUTTONS UNDER
WATER.
1. Watch is water-resistant only as long as lens, push buttons and case remain intact.
2. Watch is not a diver watch and should not be used for diving.
3. Rinse watch with fresh water after exposure to salt water.
4. Shock-resistance will be indicated on watch face or case back. Watches are designed
to pass ISO test for shock-resistance. However, care should be taken to avoid
damaging crystal/lens.
ON THE WATCH
Your watch can be setup using two methods:
• TIMEX Connected app (the easiest method) or
• The setup functions directly in the watch
SETTING THE TIME/DATE
Setting the time manually on the watch will clear all appointments previously loaded to the
watch.
1. From the Time of Day screen, press and hold the Set/Recall button.
2. Push the Start/Split button to select first or second time zone.
3. Push the Mode button, use the Start/Split and/or Stop/Reset buttons to adjust the hour
digits (remembering to pay attention to the AM/PM designation).
4. Push the Mode button, use the Start/Split and/or Stop/Reset buttons to adjust the minute
digits.
5. Push the Mode button, use the Start/Split and/or Stop/Reset buttons to reset the second
digits to 00.
6. Push the Mode button, use the Start/Split and/or Stop/Reset buttons to adjust the month.
7. Push the Mode button, use the Start/Split and/or Stop/Reset buttons to adjust the day.
8. Push the Mode button, use the Start/Split and/or Stop/Reset buttons to adjust the year.
9. Push the Mode button, use the Start/Split button to select 12-hour format or 24-hour
format.
10. Push the Mode button, use the Start/Split button to select MM-DD or DD-MM date
format.
11. Push the Set/Recall button if Done to confirm and exit or Push the Start/Split button to
change to Time 2 settings and repeat steps 3 through 11.