Filter
Top Products
TIMEX
®
IRONMAN
®
Classic 50 Move+ Owner’s Manual Page 9
10. To delete the latest stored workout, push and hold the Stop/Reset button for three
seconds. To delete all stored workouts, push and hold the Stop/Reset button for six
seconds.
NOTES:
• Upon entering Chrono mode, a message will show on the watch face that prompts you
to the number of laps that can be stored before Chrono memory is filled; if the Chrono
memory is full you will see “MEMORY FULL” displayed. See the Review section of this
manual for information on deleting workouts.
• When splits are taken, times are frozen on the display for 10 seconds. Push the Mode
button to release the display and return to the Chrono display.
• Deleting of stored workouts can only be done in Chrono mode, Review mode is only
used for viewing stored workouts. See step 10 above for instructions.
INTERVAL TIMER
You can set up an interval workout with 2 intervals. Each interval can time up to 23 hours, 59
minutes and 59 seconds.
You can set up your interval workouts to repeat when a set of intervals is complete. Your
TIMEX IRONMAN Classic 50 Move+ will keep track of the repetitions for you and alert you
when it is time to end one interval and start the next.
Your watch can hold up to 5 interval workouts in the device memory. Interval workouts are
stored with the following information: total steps, total calorie expenditure, total distance
covered, total time and number of repetitions (if Intervals are set to Repeat at End).
1. From the Time of Day screen, push the Mode button until you see INTTMR.
2. Push the Set/Recall button to customize your interval workout.
3. Starting with INT 1, push the Mode button.
4. Push the Start/Split and/or Stop/Reset buttons to adjust the hours digits.
5. Push the Mode button, then push the Start/Split and/or Stop/Reset buttons to adjust the
minutes digits.
6. Push the Mode button, then push the Start/Split and/or Stop/Reset buttons to adjust the
seconds digits.
7. Push the Mode button, then push the Start/Split and/or Stop/Reset buttons to select
Repeat at End or Stop at End. When appropriate selection is on screen, push Mode
button.