Filter
Top Products
Timex Data Link USB Watch User Guide
Stop the Timer
To stop the timer at any point in the countdown, press STOP/RESET. The display will hold the
count where it left off and the timer icon will stop flashing.
Resume the Countdown
To resume an interrupted countdown, press START/SPLIT. The countdown will continue from
the stop point and the timer icon will resume flashing.
Stop the Alert
When the watch has reached the end of the countdown, it beeps and Indiglo flashes. To silence
the alert, press any button or the Crown. If the watch is in another mode when the timer alert
display pops up, you can press any button to return to that mode or wait for the watch to do so
automatically.
Reset the Timer
To reset the timer (return to the starting time) while it is stopped, press and hold STOP/RESET.
Exit the Timer
You can leave Timer mode at any time by pressing MODE to return to Time of Day.
If the Timer was running, it will continue to run and the timer icon will show in the Time-of-
Day display. When you return to Timer mode, the currently running timer is displayed.
Setting a Timer
To set a timer, pull out the Crown. Turn the Crown to set the hours and minutes. Press MODE
to then set the seconds.
After the time has been set, press MODE again to choose the action to occur at the end of the
countdown, as follows:
• STOP –The timer simply stops when it reaches zero.
• REPEAT – The timer automatically repeats the countdown. This continues until the
timer is stopped when you press STOP/RESET.
• CHRONO – The chronograph is started when the timer reaches zero. Note that if the
chronograph was already running, the timer instead acts as if STOP had been selected.
12