Filter
Top Products
11
F. The timer will beep for ten seconds when it reaches zero; stop the beep-
ing sooner by pressing any button.
How to Set and Use the Alarm
How To Set Alarm
A. Press SPLIT/RESET/SET/RECALL to begin setting procedures. HOURS
will begin flashing. Press START/STOP to advance hours. Note AM or
PM designation when setting hours.
B. Press MODE; TENS OF MINUTES will begin flashing. Press START/STOP
to advance.
C. Repeat for MINUTES and to switch among DAILY, WEEKDAYS and
WEEKENDS.
D. Press SPLIT/RESET/SET/RECALL to exit the SET mode.
NOTE: After every new alarm time setting, the ALARM will automatically be
armed when you exit from SET mode by pressing SPLIT/RESET/SET/RECALL.
The alarm symbol will appear, indicating the ALARM is armed. In TIME OF
DAY mode, the symbol will appear on the display indicating that the alarm
is active.
How to Set and Use the Countdown Timer
A. Press SPLIT/RESET/SET/RECALL to begin the setting procedure. The
TENS OF HOURS value will begin flashing in the display. Press START/
STOP to increase setting.
B. Press MODE. The HOURS section will flash. Again, press START/STOP to
change to the desired setting. Repeat for TENS OF MINUTES, MINUTES,
TENS OF SECONDS, SECONDS, and ACTION AT END OF TIMER.
Press SPLIT/RESET/SET/RECALL to exit SET mode.
C. Press START/STOP to begin countdown. The remaining time will be
shown in the Lower Display, while the original setting will be displayed
in Upper Display.
NOTE: You may switch to another mode without affecting timer. (In TIME
OF DAY mode, the hourglass symbol will appear in the center part of the
display while the timer is counting.) Even in another mode, timer will beep
when it reaches zero.
D. To stop the timer, press START/STOP. (YOU MUST BE IN TIMER MODE.)
E. Press START/STOP to continue, or press SPLIT/RESET/SET/ RECALL to
reset the timer to its original setting.
10
0400156-W-29 English 8/3/00 11:06 AM Page 10