Filter
Top Products
9
Split or Lap Timing
A. In CHRONOGRAPH mode, select either SPLIT or LAP by pressing
SPLIT/RESET/SET/RECALL (Note: Chrono must be at zero).
B. Begin timing (press START/STOP) as above.
C. Press SPLIT/RESET/SET/RECALL to temporarily freeze the display
and measure a split or a lap. You can now write down the split or lap
time. The watch continues counting for the next segment in the
background.
D. Press SPLIT/RESET/SET/RECALL again, and the lower display will
show the next lap or split time, and the upper display will show the
number of laps. You can count up to 99 laps in this manner.
When the event ends, press START/STOP. The watch will end timing.
The display will show the final lap time (LAP selected) or the total event
time (SPLIT selected).
E. With CHRONO stopped, press SPLIT/RESET/SET/ RECALL to review
stored lap and split data. The first push will display the lap number,
the second push will display the Lap time and Split time.
F. Press and hold SPLIT/RESET/SET/RECALL to reset the chronograph
to zero.
Using the Second Time Zone
A. From TIME OF DAY mode, press START/STOP to “peek” at the time in a
second time zone of your choice.
B. Hold START/STOP for five seconds (display shows HOLD FOR TIME 2)
to switch to Time Zone 2 permanently.
C. From TIME 2, you can “peek” at TIME 1 by pressing START/STOP, or
switch back by holding the button.
D. Set the time for TIME 2 the same way as for TIME OF DAY (TIME 1)
above. Normally all settings will be the same except for HOURS. You
could also set the same time for both, with the BEEPs on in TIME1 and
off in TIME2, for one-button switching between the settings.
How to Use the Chronograph (Stopwatch)
A. Press START/STOP to begin timing.
NOTE: You can leave CHRONOGRAPH mode while the chronograph is
running. In TIME OF DAY mode, a stopwatch symbol on the left side of
the middle display indicates that the chronograph is running.
B. Press START/STOP to stop the timing. The chronograph will stop running.
C. Press START/STOP to resume timing, adding to time.
OR Press and hold SPLIT/RESET/SET/RECALL to reset to zero.
8
0400156-W-29 English 8/3/00 11:06 AM Page 8