Filter
Top Products
BEFORE
YOU BEGIN
ASSEMBLY
13
INTRODUCTION
IMPORTANT
PRECAUTIONS
BIKE
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
BIKE
OPERATION
ASSEMBLY
POWER
Your bike is powered by a power supply. The power must be plugged into the power jack, which is located in
the front of the 920B near the STABILIZER TUBE. Some bikes also have an on/off switch located on the back
of the console.
Do not operate the bike if the power cord or plug is damaged.
If the bike appears to not be working properly, do not use the bike.
MOVING
Your bike has a pair of transport wheels built into
the FRONT STABILIZER TUBE. To move, first remove
the power supply and firmly grasp the CONSOLE
MAST, carefully tilt and roll.
Our bikes are well built and heavy, weighing up to 200 lbs! Use care and
additional help if necessary when moving.
ADJUSTING THE SEAT
To adjust the seat turn the handle into its middle position making the handle feel loose. Then, slide the seat
to a position that puts you in a comfortable pedaling range (one that keeps a slight bend in your knee while
your legs are in the extended position). Lock the mechanism by rotating it clockwise or counter clockwise until
handle tightens.
NOTE: It is recommended that you do not sit on the seat while adjusting its position.
B I K E O P E R AT I O N