Filter
Top Products
5.
Carefully remove the battery. Do not touch the electrical contacts or the circuit
board.
Check forany traces of leakage, or for any other damage. If there isa leak or any
other damage, take the transmitter to an authorized Suunto representative or
distributor for checking and repair.
6.
Check the conditionof theO-ring. Adefective O-ringmay indicatesealing orother
problems. Dispose of the old O-ring, even if it seems to be in good condition
7.
Check that theO-ring grooveand thesealing surfaceof thecover areclean. Clean
them with a soft cloth if necessary.
8.
Gently insert the new battery into the battery compartment. Check the polarity of
the battery. The "+" mark should point toward the top of the compartment and the
"-" mark towards the bottom.
NOTE
It is imperative that you wait at least 30 seconds before re-
installing the transmitter battery.
When the battery is re-installed, the transmitter sends an overpressure (“---“)
signal on code 12 for 10 seconds, after which it goes to normal operation, and
shuts down after 5 minutes.
9.
Check that thenew lubricatedO-ring isin goodcondition. Putit inthe rightposition
in theO-ring groove.Be very careful notto get any dirton the O-ring orits sealing
surfaces.
10.
Carefully put the transmitter cover into place. Note that the cover will only fit in
one position. Matchthe three slotson theinside ofthe coverwith the threeledges
below the battery.
11.
Screw the four screws back into place.
97