Filter
Top Products
28 STAR TRAC PRO BIKES O
WNER
’
S
G
UIDE
With durable, high performance components, STAR TRAC PRO BIKES are designed for heavy usage with minimal maintenance
required. To keep your bike in top condition, Star Trac strongly recommends performing the regular daily, weekly and monthly
preventive maintenance routines outlined below.Any unusual symptoms, such as a loud continuous noise during operation, should
be reported to STAR TRAC PRODUCT SUPPORT DEPARTMENT at (800) 503-1221, or USA 1-714-669-1660.
DAILY MAINTENANCE
■
Remove excessive accumulations of dust, dirt, and other substances by using a clean, soft cloth and a non-abrasive liquid clean-
er, such as Formula 409
TM
or FANTASTIK
TM
.Wipe down the exterior of the display panel, handlebars, seat,pedals, shrouds and
heart rate grips.
NOTE: DO NOT spray the cleaner directly onto the display panel or heart rate grips.
WEEKLY MAINTENANCE
Perform the following services each week:
■
Vacuum the floor under and around the bike. Move the bike to another spot, if necessary, to vacuum thoroughly.
■
Inspect the display panel mounting screws for security, and retighten if necessary.
■
Inspect the display panel keypads for wear.
MONTHLY MAINTENANCE
Perform the following services each month, or as needed:
■
Check that the seat, pedals and shrouds are secure.
■
Tighten the pedals onto their respective pedal cranks using a 5/8-inch open end wrench.
P
REVENTATIVE
M
AINTENANCE
M
ANAGER
/ M
AINTENANCE
M
ODE
After using your STAR TRAC PRO BIKE for a period of time, you may wish to change some of its settings.
MANAGER MODE
The Manager Settings allow you to query and modify the basic settings of your bike. To enter Manager Settings:
1. Press and hold the
,
and keys together.
2. A beep will sound and “MANAGER SETTINGS” will display momentarily in the Information Window.
3. Release all keys. “SERIAL NUMBER” will display in the Information Window.
NOTE: The system will automatically exit Manager Settings if no key is pressed for 30 seconds.
The following keys are used to modify MANAGER SETTINGS:
Upper and Lower Data Information Window S
CROLL Keys: Display the next and previous parameters,
respectively. Keys will repeat if held.
Increase and Decrease LEVEL Keys: Adjust the value of the displayed parameter up and down, respectively,
in increments of 1 unit . These keys do not save the new value - see OK Key below.
OK Key: Updates (saves) the value of the displayed parameter in Flash memory, and exits Manager Mode.
NOTE: To exit Manager Mode without saving any values or settings, press the QUICK START key.