Filter
Top Products
Page 9
ATTACHING THE CABLE:
1. Pull and insert the CABLE END into
the CABLE MOUNT of the CAM until the
end of the CABLE is visible in the sight
hole.
2. Secure with the four sets screws (M8)
included, using a 4MM hex key. Torque
to 15-17 N-m.
INSTALL THE CABLE:
1. Locate the loose cable end and loop
around the pulley as shown making sure
not to fray the stranded wire.
INSTALLING THE SEAT BOTTOM:
1. Using four (M8,25MM,Button Head
Bolts) and four (M8,washers) install and
tighten the SEAT BOTTOM using a 5mm
hex key socket.