Filter
Top Products
Page 5
INSTALLING THE WELDED CROSS
SUPPORT:
1. Locate the CROSS SUPPORT and align
the holes as shown.
INSTALLING THE WELDED CROSS
SUPPORT, FRONT SCREWS:
1. Use three ( M8, 25MM, Button Head
Bolt), three (M8, Nyloc Nut), and six
(M8,Washers) to install and tighten the
WELDED CROSS SUPPORT, as
shown.
2. Use one (M8, 105MM Button Head Bolt),
one (M8, Nyloc Jam Nut), and one (M8,
Washer) to install and tighten the
PULLEY assembly as shown, using a
5mm hex key socket.
INSTALLING THE WELDED CROSS
SUPPORT, BACK SREWS:
1. Use four (M8, 70MM Button Head Bolt)
and eight (M8, Narrow Washer) to install
and tighten the WELDED CROSS
SUPPORT, using a 5mm hex key
socket.
INSTALLING THE PULLEY ASSEMBLY TO
THE WELDED CROSS SUPPORT:
1. Align pulley to the WELDED CROSS
SUPPORT as shown.
2. Use a (M8, 45MM, Button Head Bolt),
one (M8, Nyloc Jam Nut) and two (M8,
Narrow Washers) to install and tighten
PULLEY assembly to the CROSS
SUPPORT using a 5mm hex key socket,
as shown.