Filter
Top Products
Page 8
INSTALLING THIGH PAD SUPPORT:
1. Install the THIGH PAD SUPPORT along
with one (M8, 20MM Socket Head
Screw), one (M8, 1MM Thick Washer),
(End Cap Without Groove), and two
(25MM ID Machine Washers). Use a
6mm hex key socket to tighten.
INSTALLING THE SEAT BACK:
1. Install the SEAT BACK WELDMENT
with UPHOLSTERY using four (M8,
16mm Socket Head Cap Screws), and
four (M8, 1MM Thick Washer) to install
and tighten the Back Rest, as shown.
2. Install the PLASTIC COVER using one
(M8, 16MM Socket Head Cap Screw)
and one (M8, 1MM thick Washer) to
install and tighten the PLASTIC COVER
to the SEAT BACK WELDMENT.
FRONT
SCREWS
BACK
SCREWS
PLASTIC
COVER