Filter
Top Products
Page 7
INSTALLING THE CAM ASSEMBLY :
5. Align the flat on the shaft with the D-
Shaped slot on the CAM ASSEMBLY.
INSTALLING THE SHIN PAD ASSEMBLY:
1. Locate one 20MM diameter SHAFT with
a flat and the SHIN PAD assembly.
2. Align the SHIN PAD assembly to the
ROM ADJUST BRACKET, as shown.
3. Insert the 20MM SHAFT with a flat.
4. Install two (M8, 20MM Socket Head Cap
Screw), two (M8, 1MM Thick Washer),
and two (End Caps Without a Groove)
and tighten screws, using a 6mm hex
key socket
6. Use one (M8, 20MM, Socket Head Cap
screw), one (M8, Washer), one (End
Cap Without a Groove) to install the
CAM ASSEMBLY to the ROM ADJUST
ASSEMBLY using a 6mm hex key
socket.