Filter
Top Products
Spinner
®
Velo XT
OWNER'S MANUAL
10
BIKE ASSEMBLY
Please refer to the separately enclosed manual for the assembly of your Spinner® Velo XT.
TESTING THE BIKE
Use this checklist to perform the bike test procedure.
Recheck all the bolts and make sure they are all tightened and that no parts are missing.
Test the handlebar and seat post to make sure they move freely and you are able to lock
them at different positions.
Check the seat to make sure it is level and tight, and does not rotate around or tilt.
Tighten and adjust as needed.
Test the seat slider for movement front to rear and check it by setting it at different settings.
Brake tension is adjustable using the red resistance knob in the front of the bike.
Pressing down on the knob will apply the brake if you need to stop quickly.
Adjust seat post and handlebar post to your needs. (Refer to page 2 for proper bike setup.)
Pedal at a moderate pace and test for proper and smooth resistance changes while
varying the amount of turns on the resistance knob.
To move the bike after testing is complete, stand in front the bike, grasp the handlebars
and tip the bike toward you until the transport wheels are touching the floor. Roll the bike
to the desired location and then gently lower the rear of the bike back to the floor. Adjust
the leveling feet so that the bike is stable.
WARNING THE FL
YWHEEL MOMENTUM OF THE BIKE WILL KEEP THE
PEDALS TURNING EVEN AFTER THE USER STOPS PEDALING OR IN THE EVENT THE
USER'S FEET SLIP OFF THE PEDALS. DO NOT DISMOUNT THE BIKE OR ATTEMPT TO
REMOVE YOUR FEET FROM THE PEDALS UNTIL BOTH THE PEDALS AND THE FLYWHEEL
HAVE STOPPED COMPLETELY. FAILURE TO COMPLY MAY LEAD TO LOSS OF CONTROL
AND SERIOUS PERSONAL INJURY.
SAVE THESE INSTRUCTIONS