Filter
Top Products
ASSEMBLY INSTRUCTIONS
7
STEP 4
NOTE:
Install the HEX BOLTS(63) as shown in the illustration above. This allows the head of the bolts to
fit inside the hex shape holes in the SEAT FRAMES(5, 6).
Attach the RIGHT HANDRAIL(8) to the RIGHT SEAT FRAME(6) with HEX BOLTS(M6x1x35mm)(63),
ARC WASHERS(M6)(78), LOCK WASHERS(M6)(80), and ACORN NUTS(M6x1)(73). Repeat on the left
side.
STEP 5
Plug the LEFT and RIGHT PULSE SENSOR WIRES(34,35) into the REAR EXTENSION WIRE(33) located
on the REAR FRAME(3). Push the plugs and any excess wire back into the opening in the REAR FRAME(3).
Refer to the Bottom View illustration. Position the SQUARE PLUG(50) with its arc indentation facing toward
the front of the bike so the wires feed out of the frame toward the front. Please note that the slot is bigger
than the SQUARE PLUG(50) to allow room for the wires.
BOTTOM VIEW
Make the arc indentation
face to the front.