Filter
Top Products
10
SET UP INSTRUCTIONS
Place the R360s RECUMBENT BIKE in the area where it will be used. It is recommended that the R360s
RECUMBENT BIKE be placed on an equipment mat. The R360s RECUMBENT BIKE is approximately
61 3/4" long (max.) x 27 1/2" wide x 36" tall. (These dimensions may vary up to one inch.) An area 4 feet
wide x 7 feet long is required for safe operation of the R360s RECUMBENT BIKE. Make sure that adequate
space is available for access to and passage around the R360s RECUMBENT BIKE.
Adjust the LEVELING CAPS(49) on the REAR STABILIZER(4) so that the Recumbent Bike
sets on the floor without rocking. Remove and reposition the LEVELING CAPS(49) on the
REAR STABILIZER(4) to level the R360s RECUMBENT BIKE.
The R360s RECUMBENT BIKE must be lifted for movement. Two people are required. Grasp
on the FRONT STABILIZER(2) and REAR STABILIZER(4) to move the R360s RECUMBENT
BIKE.
LEVELING:
MOVING:
FUNCTION INSPECTION:
Visually inspect the R360s RECUMBENT BIKE to verify that assembly is as shown in the above illustration.
Check the function of the R360s RECUMBENT BIKE. Turn the crank slowly through one complete revolution
to verify that the drive train functions properly. Press the " up " and " down " buttons on the ends of the
Handrail to verify that the Magnetic System provides different tensions.
Locate and read the WARNING LABEL(83) on the R360s RECUMBENT BIKE. Make sure that
all users read the WARNING LABEL(83).
EQUIPMENT MAT
Please note the Rear Frame of the
Recumbent Bike is adjustable, use the
longest size to determine the size of the mat.
CAUTION:
Down Button(38)
Up Button(37)