Filter
Top Products
49
Heart Rate Priority on ClubTrack 2100 Treadmills
Both contact heart rate and telemetry (e.g., Polar
®
) heart rate signal detection is available. The
default priority of heart rate input is “LOCKED INPUT.” If a telemetry signal is detected first,
contact heart rate signals are inhibited from being detected throughout the rest of the workout
session and vice-versa.
Locked/Non-Locked Heart Rate Signal Options
When the “EITHER INPUT” option is selected the heart rate source signal is not fixed during the
workout session (if the signal is lost either input will be valid). If the “LOCKED INPUTS” option
is selected then the heart rate source signal is locked on the first detected signal during the
workout. To set a heart rate signal input, or to turn off the heart rate option all together,
perform the following steps:
1. On the controller keypad, press [CLEAR], [3], [2]. At this point the screen will display
“HR INPUTS.” Press [ENTER] to select this option.
2. There are five options to handle heart rate input signals. Press the [SPEED: ?+] and
[SPEED: -] keys to scroll through the options until you find the option that you want.
Press the [ENTER] key to select that option.
The options are as follows:
“ LOCKED INPUTS“ - allows either telemetry or contact heart rate signals to be
detected. Once the controller has detected a valid input signal it will lock out the
opposite type of signal for the duration of the workout session. For example, if you start
out using contact heart rate then you are limited to using only contact heart rate during
your workout session, even if the signal is lost while performing the workout, and vice-
versa.
“ EITHER INPUT” - allows either telemetry or contact heart rate signals to be
detected. Does not lock out a particular input signal for the entire workout. This option
will detect either input signal during a workout session, but only one at a time, and only
until the other signal terminates.
“ TELEMETRY ONLY “ - locks out contact heart rate signals and will only detect
telemetry signals.
“ HAND ONLY “ - locks out telemetry signals and will only detect contact heart rate
signals.
“ BOTH HR OFF “ - turns off the ability to detect any heart rate signal. Used in rare
situations where there is excessive interference with the heart rate signals.
• During workouts where heart rate is necessary, such as the HR Zone Trainer, HR
Interval and the Fitness Test, the controller will pick up telemetry heart rate
signals so that the programs are not disabled.