Filter
Top Products
XE Series Elliptical
12
STEP 3: Connecting Arm Assembling
1. Untie the wire holding the sleeve spacer (22) in place on the rod-end bearings, located on the ends
of the connecting arms (8&9). Align the hole in the rod ends with the hole in the brackets of the
left and right Handle Bar (10&11). The rod end should be on the inner side of the Handle Bar
bracket. Secure with A 5/16x1-1/4 Hex Head bolt, 5/16x20mm Flat Washer (100) and 5/16
Nylon Nut (91) by using 13/14 mm Wrench (124) and 12mm Wrench (129).
10
100
91
22
100
11
91
22
79
8
9
79