Filter
Top Products
-18-
M1001 6" x 26" Vertical Mill
The Model M1001 will perform many types of operations
that are beyond the scope of this manual. Many of these
operations can be dangerous or deadly if performed incor-
rectly.
The instructions in this section are written with the under-
standing that the operator has the necessary knowledge
and skills to operate this machine.
If you are an inexperienced operator, we strongly recom-
mend that you read books, trade articles, or seek training
from an experienced vertical mill operator before per-
forming any unfamiliar operations.
The spindle head can be rotated vertically 45˚ both ways,
and can rotate horizontally on the column 45˚ in both
directions.
Make sure the spindle is stopped and the work area
is free from obstructions before proceeding.
Loosen the four nuts that lock the headstock in place
with a 17mm wrench (see 14on next page).
Rotate the headstock to the desired angle.
Tighten the spindle locking nuts.
Additional setup tools should be used to determine
the precise angle of the spindle head.