Filter
Top Products
-16-
M1001 6" x 26" Vertical Mill
10 Headstock lock nuts.
11 Handwheel locations.
12 Drawbar location.
The longitudinal and cross handwheels shown in
11need to be installed. The handwheel handles will
need to be installed on all the handwheels. Attach
the handwheels and handles with the hex wrench,
screwdriver, and hardware provided
Open the top cover and insert the drawbar into the
splined spindle located in the center of the front cone
pulley (see 12
The Model M1001 comes fully assembled from the factory
with the exception of one of the longitudinal handwheels
and the cross handwheel. The head has been rotated to
reduce the overall dimension of the shipping crate.
Loosen the three nuts at the column and rotate the
headstock to the "0" position on the column scale (see
10
Nuts 2 & 3
Hidden from
View
Longitudinal
Handwheel
Cross
Handwheel
Drawbar
Unscrew the filler cap and fill the reservoir with non-
detergent SAE-20 or similar way oil. Manually pump the
lever until resistance from the oil pressure is felt (see
9
Knee Feed
9 Single shot lubrication system.