Filter
Top Products
-17-
M1001 6" x 26" Vertical Mill
NOTICE
13 Spindle controls.
Make sure there are no obstructions around or
underneath the spindle.
Set the mill to the slowest RPM. See
for adjusting RPM.
Put on safety glasses, and make sure any bystanders
are wearing safety glasses and are out of the way.
Plug the machine into the power outlet and push the
ON/OFF switch to turn the mill ON, but make sure
that your hand stays over the switch. The mill should
run smoothly, with little or no vibration or rubbing
noises.
• If you hear squealing or grinding noises, turn the
machine OFF immediately. Wait for the mill to
stop moving, unplug the machine, and correct any
problems before further operation.
• If the source of an unusual noise or vibration is not
readily apparent, contact our technical support
for help at (360) 734-3482 or contact us online at
.
Complete this process once you have familiarized yourself
with all instructions in this manual and you have made
sure the machine is completely lubricated as described in
on The purpose of
the test run is to make sure the motor is working properly
before proceeding.
13 shows the location of the ON/OFF buttons and
the SPINDLE DIRECTION toggle for the Model M1001.
• The ON/OFF buttons control power to the spindle.
The SPINDLE DIRECTION toggle will change the
direction the spindle rotates. DO NOT change spindle
rotation until spindle has come to a complete stop!
Spindle Direction
ON/OFF