Filter
Top Products
10
7. Start four #10 x 3/4" Screws (9) with four #10
Star Washers (32) into the Pulse Bar (112) and
the Left and Right Handrails (88, 87).
Slide the Pulse Bar (112) as far in the direc-
tion shown as possible, and then tighten the
#10 x 3/4" Screws (9). Do not overtighten the
Screws.
Remove the wire tie from the Upright Wire (81).
Insert the pulse wire (E) from the Pulse Bar (112)
through the looped Cable Tie (99) on the right
handrail assembly (C).
9
32
Wire
Tie
81
9
32
7
112
E
99
88
87
8. Set the console assembly face down on a soft
surface to avoid scratching the console
assembly.
Remove the four indicated 1/4" x 1/2" Screws (4)
from the Console Frame (104). These are used
in assembly step 11.
Attach the Left and Right Cup Holders (36, 27)
with eight #8 x 1/2" Screws (1). Do not over-
tighten the Screws.
Console
Assembly
1
8
4
4
1
1
104
1
27
36
C