Sears NTL99011.2 Treadmill User Manual


  Open as PDF
of 36
 
7
ASSEMBLY
• Assembly requires two persons.
• Placeallpartsinaclearedareaandremovethe
packing materials. Do not dispose of the packing
materialsuntilyounishallassemblysteps.
• Theundersideofthewalkingbeltiscoatedwith
high-performance lubricant. After shipping, there
may be some lubricant on top of the walking belt
or on the shipping carton. This is normal. If there
is lubricant on top of the walking belt, wipe it off
with a soft cloth and a mild, non-abrasive cleaner.
• To identify small parts, see page 6.
• Assemblyrequiresthefollowingtools:
the included hex key
one adjustable wrench
one Phillips screwdriver
To avoid damaging parts, do not use power tools.
1. Make sure that the power cord is unplugged.
Attach the Left Wheel Cap (96) to the Base (94)
with two #8 x 3/4" Screws (2).
Attach the Right Wheel Cap (not shown) to
the Base (94) in the same way.
1
96
94
2
2. Pull the Upright Wire (81) and the base ground
wire (A) through the indicated hole in the Base
(94) using the plastic tie.
Attach the base ground wire (A) to the Base (94)
with a #8 x 1/2" Ground Screw (10).
Press the Grommet (77) into the square hole in
the Base (94).
See the inset drawing. Cut the plastic tie near
the Upright Wire (81). Be careful not to damage
the Upright Wire.
81
2
Tie
Hole
Square
Hole
10
A
94
77
Cut
81
Tie
 previous next