Filter
Top Products
22
I nspect and tighten all parts of the elliptical regularly.
Replace any worn parts immediately.
To clean the elliptical, use a damp cloth and a small
amount of mild soap. IMPORTANT: To avoid damage
to the console, keep liquids away from the console
and keep the console out of direct sunlight.
CONSOLE TROUBLESHOOTING
If the console does not display your heart rate when
you hold the handgrip heart rate monitor, or if the dis-
played heart rate appears to be too high or too low, see
step 5 on page 17.
HOW TO LEVEL THE ELLIPTICAL
If the elliptical rocks slightly on your floor during use,
see HOW TO LEVEL THE ELLIPTICAL on page 13.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
First, remove the left large and small rail covers. Then
remove all of the screws from the left outer and inner
shields; there are two sizes of screws in the left
outer and inner shields—note which size of screw
you remove from each hole. Then, gently remove the
left outer shield.
Next, locate the Reed Switch (86). Turn the Pulley (53)
until a Magnet (88) is aligned with the Reed Switch.
Loosen, but do not remove, the indicated M4 x 16mm
Screw (67). Slide the Reed Switch (86) slightly closer
to or away from the Magnet (88), and then retighten
the Screw. Then, rock the Pulley (53) forward and
backward just enough that the Magnet passes the
Reed Switch repeatedly.
Repeat these actions until the console displays correct
feedback. When the reed switch is correctly adjusted,
reattach the left outer and inner shields and the left
large and small rail covers. Note: If you have questions
regarding which screw should be in which hole, see
EXPLODED DRAWING A on page 29 and the PART
LIST on page 27.
MAINTENANCE AND TROUBLESHOOTING
67
86
53
88