Filter
Top Products
14. InsertonePadTube(13)intotheSeatFrame(8). 14
InserttheotherPadTubeintotheLegLever(9).
Slide two 6"Pads (24) onto each Pad Tube (13).
15. Pivot the Link Tube (16) on the Left Arm (5) onto
the end of the LinkTube Axle (17). Attach the Link
Tube to the Link Tube Axle with a 114"x 1 1/4"
Bolt (49) and a 1/4" Acorn Nut (62).
Tap a 1" x 1" Inner Cap (36) into the LinkTube (16).
Attach the LinkTube (16) on the Right Arm (6) to
the LinkTube Axle (17) in the same manner.
15
24
16
62
24
16. Make sure that all parts are properly tightened. The use of all remaining parts will be explained in USING THE
BODYLIFT on page 11 of this user's manual.
Before using the BODYLIFT, the cable should be adjusted. See HOW TO TIGHTEN THE CABLE on page 10
of this user's manual. In addition, pull the cable a few times to make sure that it moves smoothly over the pul-
leys. Ifthe cable does not move smoothly, refer to assembly step 9 on page 7, and correct the problem before
using the BODYLIFT.
9