Filter
Top Products
.
7o
Slide a Weld Cover (63) onto each of the indicat-
ed axles on the Front and Rear Uprights (7, 2).
The Weld Covers must be tumed so the open
sides are facing the Uprights. Lubricate the axles.
Slide a Short Riser (4) onto the axles, The Short
Riser must be turned as shown.
Hold a 3/4" J=tetainer (57) and a 3/4" Retainer Cap
(59) against the end of one of the axles. The teeth
on the Retainer must bend toward the Retainer
Cap (see the inset drawing). Tap the Retainer and
Retainer Cap onto the axle. Tap a 3/4" Retainer
(57) and a 3/4" Retainer Cap (59) ontothe other
axle.
Attach the other Short Riser (4) to the upper axles
on the other side of the Front and Rear Uprights
(7, 2) in the same manner.
Pull back the Knob (39) on the Selector (20, 26).
Raise the Selector Plate (19) to the position
shown, with the Selector Plate between the sides
of the Selector. Release the Knob, making sure
that it isengaged in one of the holes in the
Selector Plate.
Hold the 3/4" x 1/2" Spacer (64) between the
small holes in the lower end of the Selector (20,
26). Attach the Spacer with a 1/4" x 1 1/4" Bolt
(49) and a 1/4" Nylon Jam Nut (55).
2
Lubricate
57 59
Axle Teeth
6