Filter
Top Products
.
Carefully cut the wire tie attached to the Cable
(25). Wrap the loop of Cable from steps 4 and 5
around the 3 1/2" Pulley (27) as shown. Hold the
Pulley and the Pulley Covers (88) between the
indicated holes in the Selector Plate (19). Make
sure that the Pulley Covers are turned so the
small rims are inside the loop of Cable as shown.
See assembly step 9, and make sure that the
Cable is routed exactly as shown.
Attach the Pulley Covers (88) and the 3 1/2"
Pulley (27) to the Selector Plate (19) with the 3/8"
x 2" Bolt (87) and a 3/8" Nylon Jam Nut (41).
The drawing at the right shows the correct route of
the Cable (25). Make sure that the Cable is
routed exactly as shown. Note: The letters indi-
cate the order in which the Cable is muted around
the Pulleys.
9
Wire Tie
87
Rims
Note: This section of
cable must go over the
top of the indicated pulley
exactly as shownl
25
B
D
G
E
7