Filter
Top Products
7
• To watch an assembly
video, go to
http://productvideo.co/
assembly/sears/
nordictrack or use your
mobile phone or smart-
phone to read the QR
code at the right.
• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you nish all assembly steps.
• After shipping, there may be an oily substance
on the exterior of the treadmill. This is normal. If
there is an oily substance on the treadmill, wipe
it off with a soft cloth and a mild, non-abrasive
cleaner.
• Left parts are marked “L” or “Left” and right parts
are marked “R” or “Right.”
• To identify small parts, see page 6.
• Assembly requires the following tools:
the included hex key
one adjustable wrench
one Phillips screwdriver
To avoid damaging parts, do not use power tools.
ASSEMBLY
1. Pull the Upright Wire (81) and the ground wire
(A) through the indicated hole in the Base (94).
Attach the ground wire (A) to the Base (94) with a
#8 x 1/2" Ground Screw (10).
Press the Grommet (77) into the square hole in
the Base (94).
See the inset drawing. Cut the plastic tie near
the Upright Wire (81).
81
1
94
Hole
Square
Hole
10
A
77
Cut
81