Filter
Top Products
12
88
B
87
95
96
10
10. Tighten a #8 x 3/4" Screw (2) into the Left
Outside Upright Cover (87) and into the bottom
of the left handrail assembly (B). Be careful not
to overtighten the Screw.
Press the Left Inside Upright Cover (88) against
the Left Outside Upright Cover (87) until they
“snap” together.
Repeat the steps above on the other side
with the Right Inside Upright Cover (95) and
the Right Outside Upright Cover (96).
2
2
11. IMPORTANT: To avoid damaging the Pulse
Crossbar (93), do not use power tools and do
not overtighten the #10 x 3/4" Screws (9).
Orient the Pulse Crossbar (93) as shown. Attach
the Pulse Crossbar to the Handrails (86) with
four #10 x 3/4" Screws (9) and four #10 Star
Washers (5). First, start all four Screws. Next,
slide the Crossbar as far as possible in the
direction shown by the arrow. Then, tighten
the Screws.
Make sure that the Upright Wire (81) isn’t
pinched. Firmly tighten the four 5/16" x 2 3/4"
Screws (28).
11
9
9
5
5
28
28
86
93
86
81