Filter
Top Products
Maintenance period
Check of air pressure
Check of rebound
Clean shock bushings,
check for tear and wear,
grease
Change of oil/inspection
at Scott Shock Service
Clean shock housing
Clean Lockout mechanism
New Every ride Every 8
hours
Every 40
hours
Every 1000
hours / min.
1 x year
MAINTENANCE / SERVICE GUIDE
Please clean regularly after riding off-road the shock
piston and all other parts in motion of the shock with
a soft and wet cloth or if needed with mild soap to
prevent from excessive wear and tear.
For maintenance and service please refer to the following
table:
Please check that the valve caps are always fixed
completely on the valves to avoid damages of the
valves or inner parts of the shock caused by dust.
OWNER’S MANUAL 2007
ENGLISH
15
14
DEUTSCH
FRANÇAIS
SET-UP OF REBOUND
GENIUS LC-R SHOCK
“Rebound” describes the speed the shock comes back
to its original length after absorbing an obstacle.
By using the red rebound screw (S4) you can adjust the
rebound step by step.
Please refer to the following instruction:
Ride your bike off a sidewalk (remain in the saddle)
and check how many times it bounces.
1. If it bounces 1-2 times, the set up is good.
2. If it bounces more than 3 times the rebound is too
fast. Turn the screw 1-2 “clicks” clockwise
3. If it does not bounce the rebound is too slow.
Turn the screw 1-2 “clicks” counter clockwise.
11
Rebound Knob