Filter
Top Products
5.When putting now the remote lever to position “All
Travel” the cable will pull the traction mode lever down-
ward and the shock will offer now the full travel. Check
now the set-up for perfect function of remote lever and
shock
6.In case you want to fine-tune the brake-away power
of the remote lever, you can do this by using a 2mm
allen key and by turning the allen screw (L4). In case
you want to readjust the tension of the remote control
cable you can do this by using the tension screw (L3).
[5]
1.Put the remote lever (L1) to position “lock-out”. [1]
2. Fix the remote control cable (L2) with the cable fixation
screw (S8) using a 3mm allen key (tightening torque:
3 Nm) on the lock out lever (S9). [3]
3.Put the remote lever now to position “Traction
Mode”. [1]
4.Fix the cable clamping screw (S10) using a 3mm allen
key (tightening torque 3Nm) on the traction mode lever
(S11). [4]
BASIC SET-UP OF THE REMOTE
CONTROL OF GENIUS TC SHOCK PLEASE NOTE
For the set-up of the shock we recommend to use
the tools listed below:
- a shock pump with a scale up to 20 bars/300 psi
with a special air valve connector preventing from
air getting away while removing the pump from
the shock valve and granting exact air pressure.
-Therefore we recommend the Scott Shock Pump
which you can order at your local Scott-Dealer
with parts number 15.1.834.208.0.000
- the SAG-Boy on the back of this manual
Please clean regularly after riding off-road the shock
piston (S12) and all other parts in motion of the shock
with a soft and wet cloth to prevent from excessive
wear and tear.
5
2 mm allen keg
OWNER’S MANUAL 2007
ENGLISH
05
04
DEUTSCH
FRANÇAIS
RECOMMANDED TOOLS FOR
THE SHOCK SET-UP
3 4
Traction Control-Functions
Position lockout
Traction mode
All travel
1