Scott LC-R Bicycle User Manual


 
IMPORTANT
Riding a defective or not properly working shock
can result in the loss of control over the bike and
may cause severe or dangerous injuries!
The Scott Genius Shock is pressurised. Never
open, disassemble or rework the shock. Only a
qualified and authorized Scott service staff/
shock service center should do this.
To open a shock which is under pressure can be
dangerous and may cause injuries!
The Scott Genius Shock always must be adjusted
to the rider’s weight to warrant perfect function.
Therefore check before every ride the shock for
fitting air pressure.
The owner of the shock is responsible for the costs
of the service.
To ship the shock to Scott or the shock service
authorized by Scott please contact your local Scott
dealer.
In case you want to disassemble the shock from the
bike for service or other reasons please note the recom-
mended tightening torque of 10Nm for the shock bolts.
Scott recommends strongly the use of a torque key
to prevent from damages on shock, shock bushings
or frame.
In addition the shock bolts should be fixed with Loctite
medium (blue) to prevent the bolts from getting unscrewed.
Damages caused by improper assembly or bad mainte-
nance as mentioned above, are not covered by warranty.
Once the recommended check up is made by Scott or a
shock service authorized by Scott, it is reported in the
maintenance schedule at the end of the manual, which
will then enable you to claim for warranty within the
warranty period.
OWNER’S MANUAL 2007
ENGLISH
17
16
DEUTSCH
FRANÇAIS