Filter
Top Products
7
40
2. Attach the Frame (1) to the Crossbar (3) with two
M10 x 95mm Bolts (34) and two M10 Nylon
Locknuts (35). Do not tighten the Nylon
Locknuts yet.
Press two 8mm Bushings (32) into the indicated
locations on the Frame (1).
Press a 75mm x 50mm Inner Cap (20) into the
Frame (1).
3. Press two 50mm Square Inner Caps (22) into the
Front Stabilizer (2).
Attach the Front Stabilizer (2) to the Frame (1)
with two M10 x 65mm Bolts (36), two M10
Washers (27), and two M10 Nylon Locknuts (35).
Tighten the M10 Nylon Locknuts (35) used in
steps 1–3.
4. Press four 20mm x 40mm Inner Caps (43) into
the Backrest Frames (10). Orient the Backrest
Frames as shown. Note: The indents in the
Backrest Frames must be on top.
Attach the Backrest Bracket (9) to the Backrest
Frames (10) with four M8 x 55mm Carriage Bolts
(40) and four M8 Nylon Locknuts (42). Do not
tighten the Nylon Locknuts yet.
Attach the Backrest (8) to the Backrest Frames
(10) with four M6 x 50mm Bolts (39) and four M6
Washers (19). Do not tighten the Bolts yet. The
Backrest must be oriented as shown.
20
1
3
34
32
32
2
2
36
22
22
27
35
1
3
19
39
10
Indent
43
43
39
9
8
4
19
42
42
35
5. Screw the Backrest Adjustment Knob (30) into the
Frame (1). Pull the Knob out as far as it will go
and lower the Backrest Bracket (9) between the
two tubes on the Bench Frame. Snap the Knob
into an adjustment hole in the Backrest Bracket.
Lubricate an M10 x 140mm Bolt (37). Attach the
indicated holes in the Backrest Frames (10) and
the two Plastic Plates (26) to the Bench Frame
(1) with the Bolt, two M10 Washers (27), and an
M10 Nylon Locknut (35). Note: The warning
decals on the Plastic Plates must face away
from the bench. Do not overtighten the M10
Nylon Locknut; the Backrest (8) must be able
to pivot easily.
37
10
8
26
30
1
26
9
35
27
27
Lubricate
Hole
Adjustment
Hole
5
Decal