Filter
Top Products
8
6
7
6. The Console (9) requires four 1.5V “D” batteries
(not included); alkaline batteries are recommended.
IMPORTANT: If the exercise cycle has been
exposed to cold temperatures, allow it to warm
to room temperature before inserting batteries
into the Console. If you do not do this, the con-
sole displays or other electronic components
may become damaged. Press the tab on the bat-
tery cover and remove the battery cover. Next,
insert four batteries into the Console. Make sure
that the batteries are oriented as shown by the
diagram inside the battery compartment. Then,
reattach the battery cover to the Console.
7. Note: A long cable may be attached to the
Console (9). The long cable is used during the
manufacturing process. Remove and discard the
long cable before continuing this step.
Have a second person hold the Console (9) near
the Handlebar Post (6). Connect the console wire
harness to the Upper Wire Harness (55). Next, con-
nect the game wire that has a tag to the Controller
Wire (54) that has a tag. Then, connect the other
game wire to the other Controller Wire.
Attach the Console (9) to the Handlebar Post (6)
with four M4 x 16mm Screws (58). Tip: Avoid
pinching the wires in the Console.
9
54
55
58
6
Game
Wires
Console
Wire
Harness
Battery
Cover
Batteries
9
8. Turn the Seat Post Knob (20) counterclockwise sev-
eral turns to loosen it. Next, pull the Seat Post Knob
outward, and insert the Seat Post (11) into the
Frame (1). Slide the Seat Post upward or downward
to the desired position, and release the Seat Post
Knob. Move the Seat Post up or down slightly to
make sure that the Seat Post Knob is engaged
in one of the adjustment holes in the Seat Post.
Then, turn the Seat Post Knob clockwise to tighten it.
11
20
1
8