Filter
Top Products
17
Inspect and properly tighten all parts of the exercise
cycle regularly. The exercise cycle can be cleaned
with a soft, damp cloth. To prevent damage to the con-
sole, keep liquids away from the console and keep the
console out of direct sunlight.
TIGHTENING THE PEDALS
For best performance, regularly tighten both pedals.
CONSOLE TROUBLESHOOTING
If the console display becomes dim, the batteries
should be replaced. See assembly step 6 on page 8
for replacement instructions. If the console does not
display your heart rate when you use the handgrip
pulse sensor, see step 5 on page 13.
HOW TO LEVEL THE EXERCISE CYCLE
If the exercise cycle
does not sit flat on
your floor, turn one or
both of the leveling
feet until the exercise
cycle is level.
HOW TO ADJUST THE BELT
If the pedals slip while you are pedaling, even while
the resistance is adjusted to the highest setting, the
belt may need to be adjusted. To adjust the belt, the
pedals and side shields must first be removed. Using
an adjustable wrench, turn the right pedal counter-
clockwise and remove it. Then, turn the left pedal
counterclockwise and remove it. Remove the screws
from the right side shield, and then carefully remove
the side shields.
Loosen, but do
not remove, the
three indicated
screws (A).
Insert the shaft
of a screwdriver
downward
between the
Pulley (22) and
the idler (B). Pull
the top of the
screwdriver
toward the rear
of the exercise
cycle until the
Belt (28) is tight. Then, tighten the three screws.
Reattach the side shields, and then reattach the ped-
als. To attach the pedals, turn the right pedal clock-
wise and turn the left pedal counterclockwise.
Leveling
Feet
28
A
B
22
MAINTENANCE AND TROUBLESHOOTING