Filter
Top Products
7
3. While another person holds the Handlebar Post (6)
near the Frame (1), connect the Upper Wire
Harness (55) to the Lower Wire Harness (51). Next,
pull the excess Upper Wire Harness out of the top
of the Handlebar Post, and slide the Handlebar
Post onto the Frame. Tip: Avoid pinching the
Wire Harnesses during this step.
Attach the Handlebar Post (6) to the Frame (1) with
three M10 x 50mm Button Screws (46) and three
M10 Split Washers (63); tighten the two Button
Screws in the front of the Handlebar Post first,
and then tighten the third Button Screw.
3
63
63
63
46
46
1
55
51
6
4
4. Attach the Water Bottle Holder (18) to the
Handlebar Post (6) with two M4 x 19mm Screws
(33).
6
18
33
5
5. Have a second person hold the Handlebar (7) near
the Handlebar Post (6). Insert the Controller Wires
(54) into the hole in the Handlebar Post and pull
them upward out of the top of the Handlebar Post.
Attach the Handlebar (7) to the Handlebar Post (6)
with two Black M10 x 50mm Button Screws (64),
two Black M10 Curved Washers (61), two M10
Curved Washers (36), and two M10 Nylon Locknuts
(48).
Tip: Avoid pinching the wires during this
step.
48
36
55
Hole
61
61
54
7
6
64
36