Filter
Top Products
15
The program will continue in this way until the
speed setting for the last segment is shown in the
C
urrent Segment column and the last segment
ends. The walking belt will then slow to a stop.
If the speed or incline setting is too high or too low
at any time during the program, you can manually
override the setting by pressing the Speed or
Incline buttons. Every few times a Speed button is
pressed, an additional indicator will light or darken
in the Current Segment column. (If any of the
columns to the right of the Current Segment col-
umn have the same number of lit indicators as the
Current Segment column, an additional indicator
may light or darken in those columns as well.)
Note: If you manually override the speed or in-
cline setting, when the next segment begins,
the treadmill will automatically adjust to the
speed and incline settings for the next seg-
ment.
To stop the program temporarily, press the Stop
button. The Time display will begin to flash. To
restart the program, press the Start button or the
Speed increase button. After a moment, the walk-
ing belt will begin to move at 1 mph. When the
next segment of the program begins, the treadmill
will automatically adjust to the speed and incline
settings for the next segment.
F
ollow your progress with the displays.
See step 6 on page 12.
Measure your heart rate if desired.
See step 7 on page 13.
When you are finished exercising, remove the
key from the console.
When the program ends, make sure that the in-
cline of the treadmill is at the lowest setting.
Next, remove the key from the console and put it in
a secure place.
Note: If the displays and various
indicators on the console remain lit after the
key is removed, the console is in the “demo”
mode. See page 25 and turn off the demo
mode.
When you are finished using the treadmill, move
the reset/off circuit breaker to the off position and
unplug the power cord.
7
6
5