Filter
Top Products
28
PROBLEM: The walking belt is off-center or slips when walked on
SOLUTION: a. If the walking belt is off-center, first remove the
k
ey and UNPLUG THE POWER CORD. If the
walking belt has shifted to the left, use the hex
k
ey to turn the left idler roller bolt clockwise 1/2 of
a turn; if the walking belt has shifted to the
right, turn the left idler roller bolt counterclockwise
1/2 of a turn. Be careful not to overtighten the
walking belt. Then, plug in the power cord, insert
the key, and run the treadmill for a few minutes.
Repeat until the walking belt is centered.
b. If the walking belt slips when walked on, first re-
move the key and UNPLUG THE POWER CORD.
Using the hex key, turn both idler roller bolts clock-
wise, 1/4 of a turn. When the walking belt is cor-
rectly tightened, you should be able to lift each
edge of the walking belt 2 to 3 in. (5 to 7 cm) off
the walking platform. Be careful to keep the walk-
ing belt centered. Then, plug in the power cord, in-
sert the key, and carefully walk on the treadmill for
a few minutes. Repeat until the walking belt is
properly tightened.
PROBLEM: The console display has lines running through it
SOLUTION: a. If lines appear in the console display, see THE INFORMATION MODE on page 23 and adjust the
contrast level of the display.
PROBLEM: The crosswalk arms squeak during use
SOLUTION: a. Note: Correcting this problem requires a small
amount of white marine grease, available at hard-
ware stores.
Turn the Resistance Knob (114) counterclockwise
and remove it. Next, remove the Resistance Cone
(116) with the Crosswalk Arm (121).
Apply a thin layer of white marine grease to the
outer surface of the Resistance Cone (116). Then,
reattach the Resistance Cone with the Crosswalk
Arm (121) and the Resistance Knob (114).
a
b
114
121
116
a