Filter
Top Products
10
7. Identify the Left Base Cover (88) and the Right
Base Cover (91). Slide the Left Base Cover onto
the Left Upright (84). Slide the Right Base Cover
onto the Right Upright (85).
91
85
84
8
8
7
8. Remove the Resistance Knob (114) from a re-
sistance mechanism. Make sure that the 3/8" x
4 3/4" Bolt (120) stays inside the resistance
mechanism and that the resistance mecha-
nism does not come apart. Note: See the
lower drawing to reassemble the resistance
mechanism if necessary.
Apply a small amount of the included grease
around the Resistance Cone (116) and around
the Upright Insert (115) in the Left Upright (84).
Insert the Resistance Cone (116) into the
Upright Insert (115), with the two large holes on
top as shown. Then, tighten the Resistance
Knob (114) onto the 3/8" x 4 3/4" Bolt (120). Do
not fully tighten the Resistance Knob.
Attach the other resistance mechanism to
the Right Upright (85) as described above.
114
Large
Holes
Resistance
Mechanism
120
114
115
85
Large
Holes
116
120
84
8