Filter
Top Products
8
CAM ADJUSTMENTS
NRG
™
Hybrid Cam:
Draw Length: To change the draw length in 1" increments
the modules must be changed on both the top and bottom
cams. See your PSE dealer for information on how to
obtain replacement modules. For minor changes, the bow
must be placed in a suitable bow press and with the
tension relieved from the string/cable, move the string to
the "+" peg on the top cam to increase the draw length by
approximately 3/8" or to the "-" peg to decrease the draw
length by approximately 3/8".
Draw Stop: The draw stop is located on the bottom cam and
is attached with two screws. It must be placed in the position
that corresponds with the modules. For example, if the bow
is equipped with size 7 modules, the draw stop must be
secured firmly with the screws in the number "7" holes.
Let-off: The let-off adjustment is part of the draw stop. To
adjust from the factory setting of 80% to 65%, remove both
screws which hold the stop to the cam and flip it over so that
the cable will contact the side marked "65" at full draw and
reinstall the screws. Note: Changing the let-off from 80% to
65% shortens the draw length by approximately 3/8".
NRG
™
Hybrid Cam
TOP
NRG
™
Hybrid Cam
BOTTOM
Draw Stop: The position of the draw stop must match the
size of the module. If the bow is equipped with a size 7
module, the draw stop must be attached to the cam using
the holes marked with the number 7. The size 4 Centerfire
™
and Rimfire
™
modules are the only exceptions to this rule
as the module and stop are one piece.
Let-off: Let-off adjustment is part of the draw stop. To
adjust from 80% to 65%, remove both screws which hold
the stop to the cam, flip the stop over so that the cable will
contact the side marked 65% at full draw and reinstall the
screws. There is no let-off adjustment for the size 4
Centerfire
™
module. The Rimfire
™
cam has no provision for
let-off adjustment.