Filter
Top Products
6
SIGHT ADJUSTMENT:
When adjusting the sight pin locations, always remember to "follow the
group". That is, if the shot group is to the left of the target, move the sight pins
to the left. If the shot group is low, move the sight pins down.
SETTING-UP YOUR BOW
••
•
INSTALLATION OF ACCESSORIES
Arrowrest/Overdraw: The arrowrest or overdraw should be
installed according to the instructions received with the
product. It is usually mounted to the riser in the threaded hole
on the side opposite the shelf (hole "A") using the hardware
provided with the arrowrest or overdraw.
Sight: The sight should be installed according to the
instructions received with the product. It is usually mounted to
the riser in the threaded holes (holes "B") on the side opposite
the shelf using the hardware provided with the sight.
Stabilizer: The stabilizer should be mounted
according to the manufacturer's recommendation. It is usually
mounted in the threaded hole on the front of the riser (hole "C").
Bow Sling: The bow sling attaches to the riser of the bow
generally with the stabilizer. If a stabilizer is not used, attach the
sling to the riser with the correct sized bolt using the hole pro-
vided for the stabilizer (hole "C").
Hole
A
Holes
B
Hole
C
CABLE GUARD ADJUSTMENT & INSTALLATION:
Install the cable guard as shown in Figure A.
Adjust the cable guard so the cables just clear the
arrow vanes. On bows using an offset cable guard
rod, adjustments must be done with the rod in the
up position (approximately 1 o’clock) as shown in
Figure B (11 o’clock for left handed bows).
Excessive arrow clearance may cause the
cable to track incorrectly on the wheels
and cause personal injury and/or
damage to the bow.
Figure A
Figure B