Filter
Top Products
7
OTHER ADJUSTMENTS
Draw Weight: Your bow is factory-set to within 2 lbs. of the peak draw
weight indicated on the label on the lower limb of the bow. Changes in draw
weight can be made by turning the limb bolt in or out. Before making any
changes in weight, turn the limb bolt clockwise until it no longer moves.
Never use extreme torque when turning the bolt or damage to the limb may
occur. The limb bolt then may be turned counterclockwise to obtain the
desired weight, but NEVER more than 4 turns or revolutions. Adjust
each limb exactly the same. CAUTION: On some bow models, the limb bolt
locking screw MUST be loosened BEFORE adjusting.
Wheels/Cams: Many PSE wheels and cams have adjustable features.
Each one comes from the factory set-up and ready to use but there may
be occasions where you need to adjust the characteristics of your bow. In
some cases you will need a PSE Tune Chart to determine what to adjust,
and you may need to see a PSE Dealer for information. If you are not sure
of the adjustment you are making, stop and see your PSE Dealer for
assistance. In all cases, an appropriate bow press will be needed to make
adjustments to cams and wheels. If you do not have an appropriate press,
see your PSE Dealer.
Centerfire
™
, Rimfire
™
& NRG
™
One Cams:
Draw Length: To change the draw length in 1" increments
the module must be changed. See your PSE Dealer for
information on how to obtain a replacement module. For
minor changes in draw length, the bow must be placed in a
suitable bow press and with tension relieved from the
string/cable.
For Centerfire
™
: Move the string from the "B" peg to the "C"
peg to shorten draw by approximately ¼" or to the "A" peg
to lengthen draw by approximately ¼". The string can also
be moved from the "2" peg to the "3" peg to shorten draw
by ¼" or to the "1" peg to lengthen draw by approximately
¼".
For NRG
™
: Each side of the cam has two posts. Moving the
string from the post with the dot to the post without a dot on
the string side of the cam increases the draw length by
approximately 3/8". Moving the string from the post with the
dot to the post without a dot on the take-up side of the cam
decreases the draw length by approximately 1/8".
For Rimfire
™
: There are two posts on the string side of the
cam. The bow is shipped from the factory with the string on
the far peg. Moving the string to the peg nearest the string
groove increases draw by approximately 1/2".
CAM ADJUSTMENTS
Yoouur
Auutthooriizzeed
PSE
Deealeer
iiss
ssuuppliieed
wiitth
tteecchniiccal
iinffoormattiioon
oon
PSE
boowss
and
ccamss.
Pleeassee
sseeee
yoouur
Deealeer
ffoor
assssiissttanccee
wheen
makiing
ttheessee
adjuussttmeenttss.
Rimfire
™
NRG
™
Centerfire
™