Filter
Top Products
7
2
. Attach a Wheel (66) to the base of the Uprights (69) with
a Wheel Bolt (64) and a Wheel Nut (32) as shown. Do
not overtighten the Wheel Bolt; the Wheel should turn
freely.
With the help of a second person, carefully tip the tread-
mill onto its other side. See assembly step 1 and attach
the other Extension Leg (63) and Base Pads (57). Next,
a
ttach the other Wheel (66) as described above.
With the help of a second person, carefully tip the tread-
mill so the base of the Uprights (69) is flat on the floor.
6
6
3
2
69
64
2
42
71
4. Have another person hold the Console Base (47) near
the right Handrail (71). If there is a green ground wire
on the Console Base, attach the end of the ground wire
to the indicated small hole in the right Handrail with the
Silver Ground Screw (75).
Connect the Wire Harness (42) to the wire harness on
the Console Base (47). Make sure to connect the con
-
nectors properly (see the inset drawing). The con-
nectors should slide together easily and snap into
place. If the connectors do not slide together easily and
snap into place, turn one connector and try again.
IF THE
CONNECTORS ARE NOT CONNECTED PROPERLY,
THE CONSOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON.
75
47
Ground
Wire
4
3. If there is a board between the Uprights (69), remove the
board and the two bolts. Discard the board and the bolts.
Remove the tie from the Wire Harness (42). Hold one of
the Handrails (71) near the right Upright (69), and route
the Wire Harness into the opening in the bottom of the
Handrail and out of the indicated hole in the top.
Set the Handrail (71) on the right Upright (69). Tighten
two Leg/Handrail Bolts (93) with two Handrail Star
Washers (95) into the Handrail and the right Upright.
Make sure that the Wire Harness (42) is not pinched.
Attach the other Handrail (71) to the left Upright (69) as
described above. Note: There is not a wire harness on
the left side.
69
69
42
93
95
71
95
93
71
3
42