ProForm PFTL99106.0 Treadmill User Manual


 
9
If you purchase the optional chest pulse sensor, follow the steps below to install the receiver included
with the chest pulse sensor.
1. Make sure that the key is removed from the con-
sole and that the power cord is unplugged.
Remove the indicated Screw (3) and the Access
Door (76) from the back of the Console Base (85).
2. Connect the wire on the receiver (A) to the indicated
wire extending from the Console Base (85). Hold
the receiver so the small cylinder is oriented as
shown and is facing the Console Back. Attach
the receiver to the plastic posts on the Access Door
(76) with the two included small screws.
3.
Make sure that no wires are pinched. Reattach
the Access Door (76) with the Screw (3). Discard
the other wires included with the receiver.
A
85
Small
Cylinder
3
76
Wire
Small
Screws
9. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear
plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread-
mill. Note: Extra hardware may be included. Keep the included hex key in a secure place; the hex key is used
to adjust the walking belt (see page 23).
8
. Raise the Gas Spring (92) to a vertical position. Remove
the Spring Pin (25) from the raised end of the Gas Spring
as described in step 7. If necessary, rotate the Gas
Spring to align the end of the Gas Spring with the ball on
t
he bracket on the Frame (58).
Next, press the Incline increase and decrease buttons
until the ball on the bracket is aligned with end of the
Gas Spring (92). Then, press the end of the Gas Spring
onto the ball. Note: It may be necessary to press the end
of the Gas Spring onto the ball while the Frame (58) is
moving.
See drawing 8a. Insert the Spring Pin (25) into the two
indicated small holes in the end of the Gas Spring (92).
Then, rotate the Spring Pin until it clips onto the Gas
Spring. Then, press the Incline decrease button until the
treadmill is at the lowest incline level, and unplug the
power cord.
25
92
Holes
25
92
8
8a
5
8
B
racket